Sidebar
x40:how_to_connect_printer_to_wiibuilder
Table of Contents
Connect Printer to Wiibuilder
You have purchased our Independent Dual Extruder 3D printer X40 
.
Here is the method to Connect Printer to Wiibuilder
If you still have questions, please contact our customer service. Email:saleservice@entina3d.com
The first way : The network connection
Step1: After configuring the network through the web page or Wiibuilder, obtain the IP address.（See “Set Up Wi-Fi Network” ）
Step2: Open the Wiibuilder. Click“WLAN Connection”, enter the IP address, click“Connect”.
The second way : USB cable connection
Step1: Connect the printer and computer with a USB cable.
Step2: You need to download the CH340 driver (on the download page) for the first connection.
Step3: Open the Wiibuilder. Click“WLAN Connection”,choose “COM3”for Windows or “/dev/*” for MacOS, click “Connect”.
x40/how_to_connect_printer_to_wiibuilder.txt · Last modified: 2022/04/22 03:30 by editor
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
